Roon
Roon works out of the box. Every Verox device runs Roon Bridge, so once it’s on your network, Roon can find it and play to whatever DAC you’ve connected.
Adding your device to Roon
- In Roon, open Settings → Audio.
- Your Verox device shows up in the Roon Bridge section, under its device name, with the audio outputs it has: your HAT, HDMI or USB DAC.
- Click Enable next to the output you want to use and give the zone a name.
That’s it: the new zone is ready to play.
Tip
Don’t see your device? Give it a minute after it starts up, and check that it’s on the same network as your Roon Core. A USB DAC has to be switched on to show up.Roon settings in Verox
Roon has its own tab in Services, with one switch: Roon Bridge. It’s on by default. Turn it off only if you don’t use Roon on this device.
Two more tabs only work with Roon:
- Display — show what’s playing on an official Raspberry Pi touchscreen
- Remote — control Roon with a USB remote
Using Roon alongside other services
If you also use AirPlay, Spotify Connect or another service on this device, Convenience Switching pauses Roon when another service starts playing, and the other way round. Roon needs a one-time setup step for this: pick Verox Remote Control as the zone’s external source control. The Services page explains how.
Roon can also play to this device over AirPlay, Squeezebox or HQPlayer instead of Roon Bridge. If you do that, enable Controlled by Roon on that service’s page. For AirPlay, also enable Force AirPlay 1, since Roon only speaks AirPlay 1 (see AirPlay).
Troubleshooting
Roon plays over AirPlay, but you hear nothing
This can happen on a network split into VLANs, with the router copying device announcements (mDNS) from one network to another. Roon then takes the router’s address for your Verox device and sends the music there. Roon shows the zone as playing, but nothing reaches your DAC.
The fix is on the computer running your Roon Core: make sure it only sees your Verox device’s own announcements, not the copies from the router. Or put your Roon Core on the same network as your Verox devices. Restart Roon afterwards, as it remembers the address.
Roon Bridge doesn’t start or doesn’t show up
If your device doesn’t show up in Roon at all, use Reinstall Roon Bridge in Advanced settings. It reinstalls Roon Bridge from scratch; reboot the device afterwards. Still stuck? Use Send Feedback and ask on the community forum.
The touchscreen or remote shows nothing, or the wrong zones
This can happen when there’s more than one Roon Core on your network, for example an old one that’s still running. The touchscreen, the remote and Convenience Switching all go through the Verox Remote Control [device name] extension, and that extension works with one Roon Core at a time.
Verox stays with the Roon Core you paired it with, also after a restart. If that Roon Core can’t be reached for more than a minute, for example because it starts up more slowly than your Verox device after a power cut, or because you’ve taken it offline for an update or a backup while another Roon Core keeps running, Verox pairs with another Roon Core it can find. It stays there when your own Roon Core comes back.
To fix it, open Settings → Extensions in the Roon Core you use, find Verox Remote Control [device name] and click Pair (or Enable, if that’s what Roon shows). Verox remembers your choice. If you don’t use the other Roon Core anymore, switching it off prevents this altogether.